Using Taguchi Method to Improve 3D Polishing Process Capability for Optical Fiber.

勤益科大機構典藏 > 管理學院 > 工業工程與管理系(所) > 【工業工程與管理系所】期刊論文 > Item 987654321/7203

jsp.display-item.identifier=請使用永久網址來引用或連結此文件: http://ir.lib.ncut.edu.tw/handle/987654321/7203

题名:	Using Taguchi Method to Improve 3D Polishing Process Capability for Optical Fiber.
作者:	林文燦
贡献者:	工業工程與(工程)管理系
日期:	2012-03
上传时间:	2018-05-22 14:14:37 (UTC+8)
摘要:	This study used Six Sigma DMAIC five-phase improvement procedures for an empirical research on a multinational optical interconnect manufacturer. The Taguchi method was used for the design of experiment, and the data obtained from the orthogonal table were used to determine the key factors and levels, in order to propose the optimal combination of processing parameters and levels for fiber patch cord 3D polishing. The combination of rough polishing time of 30s, polishing pressure of 0.02pa, polishing pad hardness of 65 degrees, and the fine polishing time of 80s could produce the fittest parameters for a satisfactory level, reduce the defect rate and waste of production cost, and reach the Six Sigma standard. The results proved that the improved process capability model, as constructed by this study, can effectively improve the apex offset quality of fiber patch cords. The findings can serve as references for engineers to improve the quality and production process capability.
關聯:	Advanced Materials Research.
显示于类别:	[工業工程與管理系(所)] 【工業工程與管理系所】期刊論文

文件中的档案:

没有与此文件相关的档案.

检视Licence

在NCUTIR中所有的数据项都受到原著作权保护.